7603 Retaining anaerobict, low viscosity, high strength, good oil content,
7603 Retaining anaerobic It is a single component, low viscosity, high strength, good oil content, excellent resistance to media holding anaerobic. The product between close fitting metal surfaces and cured and air separation.
Radial clearance of 0.1mm in transition metal or interference fit within the hole and the shaft holding, may be slightly greasy surface use, room temperature can reach maximum intensity, can also play a role in sealing, easy to use.
Before solidification characteristics Typical values range
Appearance green liquid
The chemical composition of the binder methacrylate
(GB / T2794-1995)
2 # rotor 20 rpm 100-200
Density (g / cm3) 1.10 1.00-1.15
(GB / T13354-1992)
Flash Point (℃)> 93
(SH / T0733-2004)
Gap fill (mm) 0.10
Fixed time (min) ≤30
After curing characteristics
Full cure time at room temperature (h) 24
Static shear strength (MPa) 28 20-35
(GB / T18747.2)
Working temperature (℃) -50-150
Chemical / solvent resistance
Under the following conditions of aging and 22 ℃ testing.
Solvent Temperature (℃) have left initial strength ratio (%)
100h 500h 1000h
Oil 125 100 100 100
Leaded gasoline 251,009,085
Brake fluid 251,009,080
Water / glycol 871,009,080
(50% / 50%)
Cleaning hollow shaft mating surfaces to remove grease and dried, it recommended back to the days 7755 to improve the cleaning effect of the cleaning agent. Apply glue evenly with the site, gum in an amount sufficient to fill the gap, according to specifications fitted to the appropriate location. Best small gap sealing larger gaps will affect cure speed. In with the gap is large, it recommended back to the days 7769 accelerator to improve the sealing effect. To ensure maximum system pressure and resistance to media layer optimal performance, the curing time in more than 24 hours, in order to ensure the layer is completely cured.
Unused glue sealed for the next reuse. Highly contaminated glue can reload the original packaging bottle, the bottle so as not to affect the performance of the remaining glue.
Should not be used on plastics, should not be used in pure oxygen and oxygen-enriched systems, not for sealing chlorine or other strong oxidizing materials.
Store away from children.
This product contains acrylic and methacrylic acid esters, eye irritation to the skin. Recommended for use in a well-ventilated place.
In case of contact with eyes and skin, immediately rinse with water.
Product safety information, please refer to the product MSDS.
Order Code: 760301,50ml / bottle, 10 bottles / box, 80 bottles / box
760303,250ml / bottle, 10 bottles / box
8-28 ℃ stored in a cool dry place.
Storage period of 18 months.